30-Second Challenge Quick test before the week resets — 30 seconds on… — Get Certified — TG.ME

⏱ 30-Second Challenge Quick test before the week resets — 30 seconds on the clock. An inspector must measure the diameter of a precision-ground pin to within 0.0001 inch, verify it is round, and record several diameter readings at different points along its length. A caliper is available but is only accurate to 0.001 inch. Given the accuracy requirement and need for repeated fine readings, which tool is most appropriate? 1️⃣ A coarse rule with wide marks 2️⃣ A go-or-no-go fixed-limit gage 3️⃣ A fine-resolution micrometer 4️⃣ A side-by-side sample check 👀 Think about it before you scroll for the answer... ✅ Correct answer: 3) A fine-resolution micrometer The stated accuracy requirement of 0.0001 inch and the need for repeated variable readings exceed the caliper's and steel rule's resolution and exceed what a go or no-go gage, which gives attribute data only, or visual comparison can provide; a micrometer with matching resolution meets the requirement. 💡 Exam tip: Match the measurement tool's resolution to the tolerance being verified, and remember that go or no-go gages give attribute pass or fail data, not variable readings. This is just one question out of hundreds in the full practice bank. Get access here: https://www.udemy.com/course/cqe-exam-prep-ultimate-question-bank/?referralCode=A194A9DA2826EE8A1FDF